Scanning
173
9
Changing the default resolution and file type 9
a For MFC models, press Menu, 5, 2, 1.
For DCP models, press Menu, 4, 2, 1.
b Press a or b to choose Col or 100 dpi, Color 200 dpi, Col or 300 dpi, Color 600 dpi,
Gray 100 dpi, Gray 200 dpi, Gray 300 dpi, B&W 200 dpi or B&W 200x100 dpi.
Press OK.
c Do one of the following:
For black and white file format:
Press a or b to choose PDF, Secure PDF or TIFF.
Press OK.
For Color or Gray file format:
Press a or b to choose PDF, Secure PDF, JPEG or XPS.
Press OK.
d Press Stop/Exit.
Changing the default file name 9
a For MFC models, press Menu, 5, 2, 2.
For DCP models, press Menu, 4, 2, 2.
b Enter the file name (up to 6 characters.)
Press OK.
Note
You cannot use a space for the first character.
c Press Stop/Exit.
Understanding the Error Messages 9
Once you are familiar with the types of errors that can occur while you are using the Scan to USB, you can
easily identify and troubleshoot any problems.
Protected Device
This message will appear if the protect switch of the USB Flash memory drive is on.
Rename the File
This message will appear if there is already a file on the USB Flash memory drive with the same name as
the file you are trying to save.
Too Many Files
This message will appear if there are too many files stored on the USB Flash memory drive.
Unusable Device
This message will appear if your USB Flash memory drive is not supported by your Brother machine.
To Next Page
Loading...
Need help?
General
