Brother 97OOPC - PT-9800 PCN USB LED Status

10
QLED lamp on USB Direct Interface (PT-9800PCN only)
On Flashing fast
Cutter error Confirm that the tape is not jammed
in the printer. If necessary, turn the
printer off and on with the power
button. If the STATUS lamp
continues to flash, contact your
Brother dealer or Brother Customer
Service.
Roller holder error
Print head overheat error
Turn the printer off and on with the
power button.
On
Flashing very
fast
EEPROM error Turn the printer off and on with the
power button. If the STATUS lamp
continues to flash, contact your
Brother dealer or Brother Customer
Service.
Circuit board error
Off On Booting —
Lamp condition
Condition Remedy
Colour Condition
— Off USB device not connected —
Green On USB device connected —
Red
Flashing HUB connected Disconnect the USB device.
Flashing fast
Noncompliant USB device
connected
Disconnect the USB device.
“Buffer full” error with USB
Direct Interface
Data sent from the bar code reader
is saved on the printer.
Do not use the bar code reader to
consecutively scan bar codes and
do not use the bar code reader with
multiple interfaces at the same time.
Flashing very
fast
Overcurrent
Disconnect the USB device and turn
the printer off and on with the
power button.
Lamp condition
Condition Remedy
Power lamp
(green)
STATUS lamp
(red)