Brother 97OOPC - Mac OS Setup

18
When using Mac OS
®
This section explains how to install P-touch
Editor 5.0 and the printer driver.
Below is the example for Mac OS
®
X 10.5.7.
1
Start up the Macintosh
®
, and insert the
CD-ROM into the CD-ROM drive.
Double-click the “PT_Series” (CD-ROM)
icon.
2
Double-click “Brother PT-9700PC
Driver.pkg” in the “Mac OS X” folder.
The Driver Installer starts up. Follow the
on-screen instructions.
3
After the installation is completed and
the screen shown below is displayed,
click [Close].
The installation of the printer driver is
completed.
Next, install the P-touch Editor 5.0.
4
Double-click “P-touch Editor 5.0
Installer.mpkg”.
The P-touch Editor 5.0 Installer starts up.
Follow the on-screen instructions.
5
When the installation is completed and
the message “Click Restart to finish
installing the software” is displayed, click
[Restart].
The Macintosh
®
is restarted.
The installation of software is completed.
Note
O Do not connect the printer to your
Macintosh
®
before P-touch Editor 5.0
installation has been completed.
O You must be logged on as a user with
administrator privileges to install this
software.
O Turn off the printer with the power button
and then with the main power switch.