Brother 97OOPC - Page 29

28
Q For network interface cable
users (Manual network
configuration)
9
For Mac OS
®
X 10.3.9
Click [Add] and choose IP Printing at the
top of the screen.
Enter the IP address of the printer into the
Printer Address box. Choose “PT-
9800PCN” from the list and click [Add]
again to add the printer to the “Printer
Setup Utility”.
For Mac OS
®
X 10.4.x - 10.6
Click [Add] and choose IP Printer / IP at
the top of the screen.
Enter the IP address of the printer into the
Address box. Choose “Brother PT-
9800PCN” from the list and click [Add]
again to add the printer to the “Printer
Setup Utility”.
0
When the screen returns to the “Printer
List” / “Print & Fax” screen, check that
the “Brother PT-9800PCN” is added, and
close the “Printer List” / “Print & Fax”
screen.
Now you can use the printer.
QInstalling the BRAdmin Light
configuration utility
The BRAdmin Light is a utility for initial setup
of Brother network connected devices. It can
also search for Brother products on your
network, view the status and configure basic
network settings, such as IP address.
For more information on BRAdmin Light, visit
us at http://solutions.brother.com/
1
Double-click “BRAdmin Light.pkg” in the
“Mac OS X” folder.
The BRAdmin Light Installer starts up.
Follow the on-screen instructions.
2
When the installation is completed and
the message “The Software was
successfully installed.” is displayed, click
[Close].
The installation of BRAdmin Light is
completed.
Note
O When specifying the Queue Name,
choose the value BRNxxxxxxxxxxxx
(where xxxxxxxxxxxx is the Ethernet
address).
Note
O For details on software, see the P-touch
Editor Help.
Note
O If you are using personal firewall
software, BRAdmin Light may fail to
detect the unconfigured device. In that
case, disable your personal firewall
software, and try using BRAdmin Light
again. Restart your personal firewall
software after the address of the
unconfigured device is set.