PMD
pulse
motor
circuit board
Machine
motor
circuit board
1)
Disconnect the
four
connectors.
2)
Push
the
five circuit board supports towards
the
inside and remove the pulse
motor
circuit board.
Replace the pulse
motor
circuit board.
3)
Place
new
pulse
motor
circuit
board
on
the
supports. Secure
the
circuit
board by pushing
down
near each
of
the
supports. The support tips
will
snap
into
position, securing the circuit board.
1) Disconnect
the
three connectors.
2)
Push
the
four
circuit board supports towards
the
inside and remove
the
machine
motor
circuit
board.
Replace
the
machine
motor
circuit board.
3)
Place
new machine
motor
circuit
board on
the
supports. Secure
the
circuit
board by pushing
down
near each
of
the
supports. The support tips
will
snap
into
position, securing the circuit board.
-48-
To Next Page
