MAKING COPIES 2 - 8
Making N in 1 copies or a poster (Page Layout)
You can reduce the number of pages for copies by using the N in 1
copy feature. This allows you to copy two or four pages onto one
page, allowing you to save paper. It is also possible to create a
poster. When you use the Poster feature your machine divides your
document into sections, then enlarges the sections so you can
assemble them into a poster. If you want to make a poster, use the
scanner glass.
1
Load your document.
2
Press Copy Options and or to select Page Layout.
Press
Set.
3
Press or to select 2 in 1 (P), 2 in 1 (L),
4 in 1 (P), 4 in 1 (L)or Poster(3 x 3).
Press
Set.
4
Press Mono Start to scan the document.
You can also press
Colour Start if you are using Poster layout
or if you are using a DCP-315CN or DCP-340CW.
5
If you are making a poster or placed the document in the ADF,
the machine scans the page and starts printing.
If you are using the scanner glass:
6
After the machine scans the page,
the LCD shows:
Press to scan the next page.
7
Put the next document on the
scanner glass.
Press
Set.
8
Repeat Steps 6 and 7 for each page of the layout.
9
After all the pages of the document have been scanned,
press to end.
■ Please make sure Paper Size is set to A4 or Letter.
■ You can use the N in 1 copy feature with 100% copy size
only.
■ (P) means Portrait and (L) means Landscape.
■ ADF is not available for DCP-115C and DCP-315CN.
Next Page?
▲ Yes ▼ No
Set Next Page
Then Press Set
To Next Page
Loading...
Need help?
General
