Brother DCP-8250DN

Chapter 2
6
Setting and changing the
Administrator Password 2
Setting up the password 2
The password you set in these steps is for the
administrator. This password is used to set
up users and to turn the Secure Function
Lock on or off. (See Setting up and changing
restricted users uu page 7 and Turning
Secure Function Lock on/off uu page 9.)
Note
Make a careful note of the administrator
password. If you enter the wrong
password, the LCD will show
Wrong Password. Re-enter the correct
password. If you forget it, please call your
Brother dealer for service.
a Press Menu.
b Press a or b to display
General Setup.
Press General Setup.
c Press a or b to display Security.
Press Security.
d Press Function Lock.
e Enter a four-digit number for the
password by pressing the buttons on the
Touchscreen.
Press OK.
f Re-enter the password when the LCD
shows Verify:.
Press OK.
g Press Stop/Exit.
Changing the password 2
a Press Menu.
b Press a or b to display
General Setup.
Press General Setup.
c Press a or b to display Security.
Press Security.
d Press Function Lock.
e Press Set Password.
f Enter the registered four-digit password
by pressing the buttons on the
Touchscreen.
Press OK.
g Enter a four-digit number for the new
password by pressing the buttons on the
Touchscreen.
Press OK.
h Re-enter the password when the LCD
shows Verify:.
Press OK.
i Press Stop/Exit.