Brother DCP-8250DN

Chapter 5
22
d Press d or c to display Duplex Copy.
Press Duplex Copy.
e Press d or c to display the following
layout options:
2side2side,
1side2side LongEdgeFlip,
2side1side LongEdgeFlip,
1side2side ShortEdgeFlip,
2side1side ShortEdgeFlip,
Off
Press the option you want.
f If you do not want to change additional
settings, press Start.
Tray selection 5
You can temporarily change the Tray Use
option for the next copy.
a Press Copy.
b Load your document.
c Enter the number of copies you want.
d Press d or c to display Tray Use.
Press Tray Use.
e Press MP>T1, MP>T1>T2
1
, T1>MP,
T1>T2>MP
1
, Tray#1 Only,
Tray#2 Only
1
or MP Only.
1
T2 and Tray#2 Only appears only if Tray 2
is installed.
f If you do not want to change additional
settings, press Start.
Note
To change the default setting for Tray Use
uu Basic User's Guide: Tray Use in Copy
mode
Adjusting Brightness and
Contrast 5
Brightness 5
Adjust the copy brightness to make copies
darker or lighter.
a Press Copy.
b Load your document.
c Enter the number of copies you want.
d Press d or c to display Brightness.
Press Brightness.
e Press d to make a darker copy or press
c to make a lighter copy.
Press OK.
f If you do not want to change additional
settings, press Start.
Contrast 5
Adjust the contrast to help an image look
sharper and more vivid.
a Press Copy.
b Load your document.
c Enter the number of copies you want.
d Press d or c to display Contrast.
Press Contrast.
e Press d to decrease the contrast or
press c to increase the contrast.
Press OK.
f If you do not want to change additional
settings, press Start.