150
Setting Dial Tone detection B
When you send a fax automatically, by
default your machine will wait for a fixed
amount of time before it starts to dial the
number. By changing the Dial Tone setting to
Detection you can make your machine dial
as soon as it detects a dial tone. This setting
can save a small amount of time when
sending a fax to many different numbers. If
you change the setting and start having
problems with dialling you should change
back to the default No Detection setting.
a Press .
b Press All Settings.
c Swipe up or down, or press a or b to
display Initial Setup.
d Press Initial Setup.
e Swipe up or down, or press a or b to
display Dial Tone.
f Press Dial Tone.
g Press Detection or No Detection.
h Press .
Telephone line interference /
VoIP B
If you are having difficulty sending or receiving
a fax due to possible interference on the
telephone line, we recommend that you adjust
the Equalization for compatibility to reduce the
modem speed for fax operations.
a Press .
b Press All Settings.
c Swipe up or down, or press a or b to
display Initial Setup.
d Press Initial Setup.
e Swipe up or down, or press a or b to
display Compatibility.
f Press Compatibility.
g
Press
High
,
Normal
or
Basic(for VoIP)
.
Basic(for VoIP) reduces the
modem speed to 9600 bps and turns
off ECM (error correction mode).
Unless interference is a recurring
problem on your telephone line, you
may prefer to use it only when
needed.
To improve compatibility with most
VoIP services, Brother recommends
changing the compatibility setting to
Basic(for VoIP).
Normal sets the modem speed at
14400 bps.
High sets the modem speed at
33600 bps.
h Press .
• VoIP (Voice over IP) is a type of phone
system that uses an Internet connection,
rather than a traditional phone line.
• Brother does not recommend the use of a
VoIP line. VoIP limitations in general can
cause some functions of the fax machine
not to work correctly.
To Next Page
Loading...
Need help?
General
