Brother DCP130C - Page 92

4-2 Confidential
Error Message Cause Action
Ink Empty One or more of the ink
cartridges is empty. The
machine will stop all print
operations.
Replace the ink cartridges.
Low Temperature
The ambient temperature is
too low.
Raise the ambient temperature. *
Media Error The memory card is either
corrupted, improperly
formatted, or there is a
problem with the memory
card.
Put the card firmly into the slot again to
make sure it is in the correct position. If
the error remains, check the media
drive by putting in another memory
card that you know is working.
Near Empty One or more of the ink
cartridges are running out
of ink.
Order a new ink cartridge.
No Cartridge An ink cartridge is not
installed properly.
Take out the ink cartridge and put it in
again seating it properly.
No File The memory card in the
media drive does not
contain a .JPG file.
Put the correct memory card into the
slot again.
The machine is out of paper
or paper is not properly
loaded in the paper tray.
Do one of the following:
• Refill the paper in the paper tray, and
then press Black Start (Mono Start)
or Color Start.
• Remove the paper and load it again
and then press Black Start (Mono
Start) or Color Start.
The jam clear cover is not
set in place.
Set the jam clear cover into place.
No Paper Fed
Paper is jammed in the
machine.
Remove the jammed paper.
The machine's memory is
full.
Reduce print resolution. Out of Memory
The data size of the
memory card is too large.
Reduce the size of the image data
stored in the memory card.
Paper Jam Paper is jammed in the
machine.
Remove the jammed paper.
* When the ambient temperature is too high or low, the print quality may deteriorate.