Brother HL-L9300CDW - 1.3.6 Software version check (Function code 25)

5-11
Confidential
1.3.6 Software version check (Function code 25)
<Function>
This function is used to check the version information of the firmware or programs, or check
sum information.
<Operating procedure>
*1
How to display the check sum information
Press the OK key for the model without a touch panel and the SET key for the model
with a touch panel when its version information is displayed on the LCD to display the
check sum information. Press the OK or SET key again to return to the version
information display.
*2
(P) indicates that the firmware supports PCL/PS.
*3
There are two types of check sum information which can be checked with this function.
This function checks if these two types of check sum information are matched each
other. When you press the OK key for the model without a touch panel and the SET
key for the model with a touch panel while “ROM Check Sum” is displayed, check is
automatically conducted for each ROM of each software part. When the check sum is
matched, “OK” is displayed on the LCD. When all ROMs result in OK, “ROM Check
Sum OK” is displayed at the end, and the operation is finished. When the check sum of
any ROM is not matched, “NG” is displayed, and the display stops.
Model without touch panel
Model with touch panel
(1) Press the or key to display
“MAINTENANCE 25” on the LCD in the
initial state of the maintenance mode.
Then, press the OK key.
“MAIN: Ver*.**” is displayed on the LCD.
(2) When you press the Go, or key,
the display on the LCD changes as
shown in the list below.
(3) Press the Cancel key to return the
machine to the initial state of the
maintenance mode.
(1) Press the 2 and 5 keys in this order in
the initial state of the maintenance
mode. “MAIN: Ver*.**” is displayed on
the LCD.
(2) When you press the Mono, or
key, the display on the LCD changes as
shown in the list below.
(3) Press the X key to return the machine
to the initial state of the maintenance
mode.
LCD Description
MAIN: Ver1.00(A) *
1
Main firmware version information
(A): Revision information
SUB1 : Ver1.00(P) *
1
Sub firmware version information
(P): Identifier of PCL/PS *
2
ENG : Ver1.00 Engine firmware version information
NET : Ver1.00 Network program version information
HV : Ver1.00 BXXX High voltage CPU program version and PCB information
PNL:T1308201900 Panel firmware version information
(Model with touch panel only)
PNLB:01308051500 Panel boot firmware version information
(Model with touch panel only)
B0608071049:5708 *
1
Boot program creation date
U0612271600:7B0A *
1
Main firmware creation date
D0611301115:E6C3 *
1
Demo firmware data creation date
F0612312359:1234 *
1
Font firmware creation date
P0612271602:BD40 *
1
Sub firmware (PCL/PS) creation date
ROM Check Sum Check sum self-diagnosis function *
3