Brother HL-L9300CDW - 3.2 Error Message

2-21
Confidential
3.2 Error Message
The error messages displayed on the LCD of the machine and their description are shown in
the table below.
■ Model without touch panel
Error Message
State
Error
Codes
Refer
to:
1st line 2nd line
Access
Denied
Function Locked.
In the case of PC-print,
authentication of print restricted
ID failed.
--- 4.10.3
Function Locked.
Job Deleted. Press
Go.
--- 4.10.3
Function Locked.
Press Go.
--- 4.10.3
Access Error Press Cancel. Put
the device back in
and try again
The USB flash memory is taken
out while data is being
processed.
--- 4.11.2
Belt End
Soon
-
Number of pages printed with the
belt unit will reach the upper limit
soon.
4300 2-50
Calibrate Calibration failed.
Insufficient Toner
for Calibration.
Dot counter or develop roller
counter of color toner has
reached the upper limit during
color density adjustment
performed from the control panel.
9802 2-76
Calibration failed.
Press Go, and try
again.
Density patch measurement
ended unsuccessfully during
color density adjustment
performed from the control panel.
9803 2-77
Error occurred with the value
measured during density sensor
sensitivity calibration.
9804 2-77
Calibration failed.
Turn the power off
and then back on
again.
Error occurred with the value
measured during color density
adjustment performed from the
control panel.
9801 2-76