5-60
Confidential
2.2 Counter Reset of Consumable Parts
(Drum Unit/Belt Unit)
<Function>
After replacing a drum unit or belt unit, perform this function to increase the replacement count
by one and reset the count to clear the “Replace ***” warning.
<Operating procedure>
The consumable parts that can be selected are shown in the table below.
Model without touch panel
Model with touch panel
(1) Press the Go and key at the same
time. “Reset Menu” is displayed on the
LCD.
(2) Press the or key to display the
part of which counter you want to reset
and press the OK key.
(3) “ Reset Exit” is displayed on the
LCD and press the key. “Accepted”
is displayed on the LCD and the
counter of the selected part is reset.
(1) Press the Settings key in the ready
state.
(2) Press the or key to display
“Machine Information” and then press
the Machine Information key.
(3) Press the or key to display “Parts
Life” and then press the Parts Life key.
(4) Hold down the X key for 5 seconds or
more. “Reset Menu” is displayed on the
LCD.
(5) Press the key of the part of which
counter you want to reset. “Reset
*****?” is displayed on the LCD. (*******
represents the selected part name.)
(6) Press the Yes key. “Accepted” is
displayed on the LCD and the counter
of the selected part is reset.
LCD Part name
Drum Drum unit
Belt Unit Belt unit
To Next Page
Loading...
