Brother HL-L9300CDW - Page 99

2-79
Confidential
■ Error code 9A03
Error occurred during patch data printing in auto color registration performed from the control
panel.
< User Check >
- Check if the toner cartridges are set in the correct order of colors.
- Replace the toner cartridge.
- Replace the drum unit.
- If the belt unit has a scratch, replace it.
- If “WT Box End Soon” is displayed on the LCD and the belt unit has dirt, replace the waste
toner box.
Registration
Registration failed. Press Go, and try again.
Step Cause Remedy
1 Dirt on the registration mark
sensor L/registration mark
sensor R
Clean the registration mark sensor L/
registration mark sensor R.
2 Connection failure of the
registration mark sensor L PCB/
registration mark sensor R PCB
harness
Reconnect the registration mark sensor L
PCB/registration mark sensor R PCB
harness.
3 Failure in printed measurement
pattern image
If failure occurs when printing “2D3S
YMCBWKW_A” in “Function code 71”,
refer to
“4.3 Troubleshooting for Image Defects” in
this chapter and take a measure.
4 Registration mark sensor L or
registration mark sensor R failure
Replace the registration mark sensor unit.
5 Main PCB failure Replace the main PCB ASSY.