Configuring your machine for a wireless network (Not available for DCP-365CN, DCP-395CN and MFC-295CN)
22
3
Step by step chart for wireless network configuration 3
For Infrastructure mode 3
a Confirm your network environment. (See page 24.)
b Confirm your wireless network setup method. (See page 25.)
c Configure your machine for a wireless network. (See page 28.)
Wireless configuration and installing drivers and software have been completed.
Infrastructure mode
Connected to a computer with an access point
or
Ad-hoc mode See page 23.
Connected to a wireless capable computer without
an access point
Using the Setup
Wizard from the
control panel
(Recommended)
Using the
SES/WPS/AOSS
control panel menu
Using the PIN
Method of Wi-Fi
Protected Setup™
Using the Brother
installer application
Temporarily using a
network cable
Using the
SES/WPS/AOSS
control panel menu
See page 28. See page 39. See page 44.
Windows
®
(See page 49.)
Macintosh
(See page 73.)
Windows
®
(See page 57.)
Macintosh
(See page 81.)
Installing drivers and software (See the Quick Setup Guide.)
To Next Page
Loading...
Need help?
General
