Brother MFC-255CW User Manual

Configuring your machine for a wireless network (Not available for DCP-365CN, DCP-395CN and MFC-295CN)
25
3
Confirm your wireless network setup method 3
There are four methods to configure your machine for a wireless network; by using the machine’s control
panel (recommended), using SES, WPS or AOSS from the control panel menu, using the PIN Method of
Wi-Fi Protected Setup™ or using the Brother installer application. The setup process will be different
depending on your network environment.
Configuration using the machine’s control panel Setup Wizard to configure
your wireless network machine 3
We recommend that you use the machine’s control panel to configure your wireless network settings. By
using the control panel Setup Wizard function, you can easily connect your Brother machine to your
wireless network. You must know your wireless network settings before you proceed with this
installation. (See Using the Setup Wizard from the control panel on page 28.)
Configuration using the SES/WPS/AOSS control panel menu
(Infrastructure mode only) 3
If your wireless access point (A) supports either SecureEasySetup™, Wi-Fi Protected Setup™ (PBC
1
) or
AOSS™, you can configure the machine without a computer. (See Using SES, WPS or AOSS from the
control panel menu to configure your machine for a wireless network on page 39.)
1
Push Button Configuration
A

Brother MFC-255CW Specifications

General

Device Type	Print server
Network Protocol	TCP/IP
Wireless Standard	IEEE 802.11b, IEEE 802.11g
Security	WEP, WPA-PSK, WPA2-PSK
Compatible Operating Systems	Mac OS X
Interface	Ethernet, USB, Wireless