Configuring your machine for a wireless network (Not available for DCP-365CN, DCP-395CN and MFC-295CN)
27
3
Configuration using the Brother installer application on the CD-ROM to
configure your wireless network machine 3
You can also use the Brother installer application on the CD-ROM we have provided with the machine. You
will be guided by the on-screen instructions until you are able to use your Brother wireless network machine.
You must know your wireless network settings before you proceed with this installation.
(See Wireless configuration for Windows
®
using the Brother installer application (For DCP-373CW,
DCP-375CW, DCP-377CW, DCP-593CW, DCP-595CW, DCP-597CW, MFC-495CW and MFC-795CW)
on page 48 or Wireless Configuration for Macintosh using the Brother installer application (For DCP-373CW,
DCP-375CW, DCP-377CW, DCP-593CW, DCP-595CW, DCP-597CW, MFC-495CW and MFC-795CW)
on page 72.)
Configuration temporarily using a network cable 3
If there is an Ethernet Hub or Router in the same network as the wireless access point (A) of your machine,
you can temporarily connect the Hub or Router to the Brother machine using an Ethernet cable (B) (not
provided), this is an easy way to configure your machine. You can then remotely configure the machine from
a computer on the network.
B
A
To Next Page
Loading...
Need help?
General
