Configuring your machine for a wireless network (Not available for DCP-365CN, DCP-395CN and MFC-295CN)
43
3
Note
• If you encounter a problem during setup, temporarily place your machine closer to the wireless access
point, and go back to step d.
• You can also manually configure the wireless settings following the steps starting at step a on page 34.
i Press .
(Windows
®
)
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Install MFL-Pro Suite or
Initial Installation / Install MFL-Pro Suite from the CD-ROM menu.
(Macintosh)
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Start Here OSX from the
CD-ROM menu.
LCD messages when using the SES/WPS/AOSS control panel menu
LCD shows Connection status Action
Setting WLAN
Searching or accessing the access point,
and downloading settings from the access
point.
—
Connecting SES
Connecting WPS
Connecting AOSS
Connecting to the access point. —
Connected Connection succeeded. —
Connection Error Session overlap has been detected.
Check that only one router or access
point has the SecureEasySetup™
mode, the Wi-Fi Protected Setup™
mode or AOSS™ mode enabled and try
starting from step d again.
No Access Point The access point detection failed.
Move the machine closer to your
access point/router and try starting from
step d again.
Connection Fail Connection failed.
Try starting from step d again.
If the same message reappears,
reset the machine back to the
factory settings and try again.
To Next Page
Loading...
Need help?
General
