Wireless Configuration for Macintosh using the Brother installer application (For DCP-373CW, DCP-375CW, DCP-377CW,
DCP-593CW, DCP-595CW, DCP-597CW, MFC-495CW and MFC-795CW)
77
5
j The wizard will search for wireless networks available from your machine. Choose the access point you
wish to associate the machine with, and then click Next.
Note
• “SETUP” is the default SSID of the machine. Do not choose this SSID.
• If the list is blank, check that the access point has power and is broadcasting the SSID, and then see if the
machine and the access point are within range for wireless communication. Then, click Refresh.
• If your access point is set to not broadcast the SSID you can manually add it by clicking the Add button.
Follow the on-screen instructions for entering the Name (SSID).
k If your network is not configured for Authentication and Encryption, the following screen will appear. To
continue installation, click OK and go to step m.
To Next Page
Loading...
Need help?
General
