Brother MFC-8220 - Scan to Image

9 - 7 NETWORK SCANNING
Scan to Image
When you select
Scan to Image
your original document will be
scanned and sent directly to the PC you designated on your network.
The Brother SmartUI will activate the default graphics application on
the designated PC. You can change the Scan configuration. (For
Windows
®
98/Me/2000: See Scan to Image on page 4-16 to 4-17.)
(For Windows
®
XP: See
Hardware Section: Changing the Scan to
button configuration
on page 5-5 to 5-11.)
1
Place the original document face down in the ADF.
2
Press (
Scan
).
3
Press or to select
Scan
to Image
.
Press
Set
.
4
Press or to select a destination you want to send.
Press
Set
.
If the LCD prompts you to enter a PIN Number, enter the 4-digit
PIN Number for the destination PC on the control panel.
Press
Set
.
The MFC will start the scanning process.
For Network Scanning the Brother Control Center (SmartUI)
selections are used only for configuring the Scan button. You
will not be able to initiate a network scan from the Brother
Control Center (SmartUI).
Select
▲▼
& Set
Scan to Image