Brother MFC-8220 - Scan to OCR

NETWORK SCANNING 9 - 8
Scan to OCR
When you select
Scan to OCR
your original document will be
scanned and sent directly to the PC you designated on your network.
The Brother SmartUI will activate ScanSoft
®
TextBridge
®
and
convert your original document into text for viewing and editing from
a word processing application on the designated PC. You can
change the Scan configuration.
(For Windows
®
98/Me/2000: See Scan to OCR (Word Processor) on
page 4-13 to 4-15.) (For Windows
®
XP: See Hardware Section:
Changing the Scan to button configuration on page 5-5 to 5-11.)
1
Place the original document face down in the ADF.
2
Press (
Scan
).
3
Press or to select
Scan
to OCR
.
Press
Set
.
4
Press or to select a destination you want to send.
Press
Set
.
If the LCD prompts you to enter a PIN Number, enter the 4-digit
PIN Number for the destination PC on the control panel.
Press
Set
.
The MFC will start the scanning process.
For Network Scanning the Brother Control Center (SmartUI)
selections are used only for configuring the Scan button. You
will not be able to initiate a network scan from the Brother
Control Center (SmartUI).
Select
▲▼
& Set
Scan to OCR