4-15
Confidential
8. IF YOU REPLACE THE TT / LT
What to do after replacement
• Installing Firmware (Main Firmware)
• Adjusting Left-end and Upper-end Print Position (TT only)
What you need to prepare
(1) One USB cable
(2) Create a temporary folder on the C drive of the computer (Windows
®
XP or later).
(3) Download utility (FILEDG32.EXE)
Copy this file into the temporary folder created on the C drive.
(4) Maintenance driver (MaintenanceDriver.zip)
When the maintenance driver is not installed on the computer, copy this file into the
temporary folder created on the C drive, and extract the copied file. Refer to “APPENDIX
3 INSTALLING THE MAINTENANCE PRINTER DRIVER” for the installation procedure.
(5) Firmware
Main firmware djf file
(ex. D001G9_A.djf)
To Next Page
Loading...
Need help?
General
