Brother MFC-9130CW - Configuration in Ad-Hoc Mode; Using Configured SSID

Configuring your machine for a wireless network (For DCP-9020CDW, MFC-9130CW, MFC-9330CDW and MFC-9340CDW)
32
3
Configuration in Ad-hoc mode 3
Using configured SSID 3
If you are trying to pair the machine to a computer that is already in Ad-hoc mode with a configured SSID,
you will need to complete the following steps:
a Before configuring your machine, we recommend you write down your wireless network settings. You
will need this information before you continue with the configuration.
Check and record the current wireless network settings of the computer you are connecting with.
NOTE
The wireless network settings of the computer you are connecting with must be set to Ad-hoc mode with
a SSID already configured. For instructions on how to configure your computer to Ad-hoc mode, please
see the information included with your computer or contact your network administrator.
For example: 3
NOTE
Your Brother machine supports the use of the first WEP key only.
b Press .
c Press Network.
d Press WLAN.
Network name: (SSID)
Communication Mode Encryption mode Network key
Ad-hoc NONE —
WEP
Network name: (SSID)
HELLO
Communication Mode Encryption mode Network key
Ad-hoc WEP 12345