Brother MFC-9325CW - Page 159

Troubleshooting and routine maintenance
147
C
Drums End Soon The drum units are near the end
of their life.
Buy new drum units before you get a
Replace Drums message.
Drum End Soon(X)
1
The drum unit for the colour
indicated on the LCD is near the
end of its life.
Buy new drum unit for the colour indicated on
the LCD before you get a
Replace Drum(X)
1
message.
DR mode in Use
(except New Zealand)
The machine is set to Distinctive
Ring mode. You can not change
the Receive Mode from Manual to
another mode.
Set Distinctive Ring to off.
For Austlaria, see Telephone Service for
Australia on page 52.
For Other countries, see Distinctive Ringing
(For Singapore and Hong Kong) on page 55.
Faxability On
(For New Zealand)
The machine is set to Faxability
mode. You can not change the
Recieve Mode from Manual to
another mode.
Set Faxability to off.
See FaxAbility on page 54.
Fuser Error The temperature of fuser unit
does not rise at a specified
temperature within specified time.
Turn the power switch off, wait a few
seconds, and then turn it on again. Leave the
machine for 15 minutes with the power on.
The machine can be turned off for up to
60 hours without losing faxes stored in the
memory. (See Transferring your faxes or Fax
Journal report on page 151.)
The fuser unit is too hot.
Init Unable XX
(XX=Error Code)
The machine has a mechanical
problem.
 Disconnect the machine from the power
for several minutes, then reconnect it.
(The machine can be turned off for up to
60 hours without losing faxes stored in
the memory. See Transferring your faxes
or Fax Journal report on page 151.)
 If the problem continues, call Brother
Customer Service.
Jam Inside The paper is jammed inside the
machine.
(See Paper jams on page 153.)
Jam Rear The paper is jammed in the back
of the machine.
(See Paper jams on page 153.)
Jam Tray The paper is jammed in the paper
tray of the machine.
(See Paper jams on page 153.)
No Belt Unit The belt unit is not installed
correctly.
Re-install the belt unit. (See Replacing the
belt unit on page 181.)
Error Message Cause Action