Brother MFC-9330CDW Quick Setup Guide

5
d Load paper in the tray and make sure:
 The paper is below the maximum paper
mark (bbb) a. Overfilling the paper tray will
cause paper jams.
 The side to be printed on is face down.
 The paper guides touch the sides of the
paper so it will feed properly.
e Put the paper tray firmly back in the machine.
Make sure it is completely inserted into the
machine.
f Lift the support flap a to prevent paper from
sliding off the face-down output tray.
4
Connect the power cord
and telephone line
a Connect the AC power cord to the machine and
then plug it into an AC power outlet.
b Press on the control panel.
c Connect the telephone line cord: connect one
end of the telephone line cord to the jack on the
machine marked LINE and the other end to a
modular wall jack.
For information about recommended paper,
see Basic User's Guide: Recommended
paper and print media.
IMPORTANT
DO NOT connect the interface cable
yet.
IMPORTANT
DO NOT touch the Touchscreen immediately
after plugging in the power cord or turning the
machine on. Doing this may cause an error.
IMPORTANT
The telephone line cord MUST be connected to
the jack on the machine marked LINE.

Brother MFC-9330CDW Specifications

Print Specifications

print speed black	up to 23 ppm
print speed color	up to 23 ppm
print resolution	up to 600 x 2400 dpi

Copy Specifications

copy speed black	up to 23 cpm
copy speed color	up to 23 cpm
copy resolution	600 x 600 dpi

Scan Specifications

scan resolution optical	1200 x 2400 dpi
scan resolution interpolated	19200 x 19200 dpi
document glass size	8.5” x 11.7”

Fax Specifications

fax modem speed	33.6k bps
fax page memory	up to 500 pages
speed dial locations	200

Paper Handling

auto document feeder capacity	up to 35 pages
paper size maximum	up to 8.5” x 14” (legal)
standard paper capacity	250 sheets

Power and Energy

deep sleep mode power consumption	<2W
automatic duplex printing	Yes
energy star qualified	Yes