2-68
Confidential
■ Error code 87
Toner of the color which is being used reaches the end of life when implementing adjustment
of color density.
<User Check>
- Replace the toner cartridge with a new one.
■ Error code 88
Paper jam inside the machine.
<User Check>
- Check if the paper is jammed. If jammed, remove it.
(Non Touch panel model)
Calibrate
Calibration failed. Insufficient Toner for Calibration.
(Touch panel model)
Calibration failed
Calibration failed. Insufficient Toner for Calibration.
Step Cause Remedy
1 Toner/New sensor PCB failure
(Toner empty)
Check the sensor performance following
the procedure described in “Function code
32”. If any problem occurs, replace the
Toner/New sensor PCB ASSY.
2 Engine PCB failure Replace the engine PCB ASSY.
3 Main PCB failure Replace the main PCB ASSY.
(Non Touch panel model)
Jam Inside
Open the Front Cover, pull out the Drum Unit completely and remove the
jammed paper.
(Touch panel model)
Animation is displayed.
Step Cause Remedy
1 Harness connection failure of
paper eject sensor PCB ASSY
Check the harness connection of the
paper eject sensor PCB ASSY and
reconnect it.
2 Paper eject actuator catching on
some position
Correct catching of the paper eject
actuator.
3 Paper eject sensor PCB failure Check the sensor performance following
the procedure described in "Function code
32". If any problem occurs, replace the
paper eject sensor PCB ASSY.
4 Engine PCB failure Replace the engine PCB ASSY.
5 Main PCB failure Replace the main PCB ASSY.
To Next Page
Loading...
