Brother MFC-9460CDN - Page 364

3-181
Confidential
(3) Remove the Taptite flat B M3x10 screw to remove the AC inlet from the Low-voltage
power supply unit.
Fig. 3-268
(4) Remove the screw “a” of the Screw pan (S/P washer) M4x8 from the Low-voltage power
supply unit to remove the ground terminal.
Fig. 3-269
Note:
When removing the screws of the Screw pan (S/P washer) M4x8, be sure to remove
the screw “a” first and then screw “b”.
Assembling Note:
When assembling the screws of the Screw pan (S/P washer) M4x8, be sure to assemble
the screw “b” first and then screw “a”.
Taptite flat B M3x10
Low-voltage power
AC inlet
Pin
supply unit
<Right side>
Low-voltage power supply unit
Ground terminal
<Right side>
Screw pan (S/P washer)
Screw pan (S/P washer)
M4x8 “a”
M4x8 “b”