Brother MFC-9460CDN - Page 471

5-33
Confidential
■ Adjusting left-end print start position on second side in duplex printing
<Function>
This function is to adjust the left-end print start position on the second side in the left and right
direction if it is displaced in duplex printing.
The adjustable range is -100 to 750 (unit: 300 dpi) (The minus direction means the left
direction.)
<Operating procedure>
(1) Press the 4 and 5 buttons in this order in the initial state of the maintenance mode.
The "USBNo." will appear on the LCD.
(2) Press the or button to display "DX.XAdjust=**" and then press the OK or Start/
Black button.
(3) To move the print start position to the left, press the button and decrease the value.
To move the print start position to the right, press the button and increase the value.
(4) When the value is changed to the adjustment value, press the OK button. "Accepted" is
displayed on the LCD, and the product goes back to the initial state of the maintenance
mode.
■ Switching ON/OFF of Deep Sleep function
<Function>
This function is to switch whether or not to permit the machine to go into Deep Sleep when
StoreData (Secure) exists in the main body.
“*” is displayed at the end of the currently specified function in the LCD display.
<Operating procedure>
(1) Press the 4 and 5 buttons in this order in the initial state of the maintenance mode.
The "USBNo." will appear on the LCD.
(2) Press the or button to display "DpSlp.StrDt =***" and then press the OK or Start/
Black button.
(3) Select "DpSlp.StrDt =ON" or "DpSlp.StrDt =OFF" by pressing the or button, and
press the OK or Start/Black button.
(4) "Accepted" is displayed on the LCD, and the machine goes back to the initial state of the
maintenance mode.
LCD Description
DpSlp.StrDt =ON
Even when StoreData (Secure) exists, the Deep Sleep function
operates.
DpSlp.StrDt =OFF
When StoreData (Secure) exists, the Deep Sleep function does
not operate. (default)
Note:
This function is enabled when the Deep Sleep function is set to ON.