Brother MFC-9460CDN - Page 571

7-47
Confidential
(44) Remove the five Taptite cup S M3x6 SR screws to remove the four Scanner holders.
Fig. 7-86
(45) Remove the Connector (CN8) and two Flat cables from the Laser unit to remove the
Laser unit from the Base frame unit.
Fig. 7-87
(46) After replacing the Laser unit, reset the counter. (Refer to “2.2 Parts Life Reset Function”
in Chapter 5.)
Assembling Note:
When connecting flat cable(s), do not insert them at an angle. After insertion, check
that the cable are not at an angle.
Taptite cup S M3x6 SR
Scanner holder
Taptite cup S M3x6 SR
Taptite cup S M3x6 SR
Taptite cup S M3x6 SR
Taptite cup S
Scanner holder
Scanner holder
Scanner holder
M3x6 SR
Base frame unit
Scanner holder
Laser unit
<Front>
Base frame unit
Laser unit
Connector
45a
45b
<Front>
Flat cable
Flat cable
45a