Brother MFC-9460CDN - Page 58

2-19
Confidential
4C The black drum unit will reach
the end of life soon.
2-49
4D The yellow drum unit will reach
the end of life soon.
2-49
4E The magenta drum unit will
reach the end of life soon.
2-49
4F The cyan drum unit will reach
the end of life soon.
2-49
50 Drum unit is at the end of life. 2-50
51 MP paper feeding kit is at the
end of life.
2-50
52 Paper feeding kit1 is at the end
of life.
2-50
53 Paper feeding kit2 is at the end
of life.
2-50
54 Fuser unit is at the end of life. 2-50
55 Laser unit is at the end of life. 2-50
56 The fuser cover is open. 2-51
57 Paper is jammed in the duplex
paper feed system.
2-51
58 Fuser unit error. (Some kind of
fixing error occurs.) (warning)
2-52
59 Fuser unit error. (After the error
code 58 occurred, a failure in the
fuser unit is detected again upon
start-up.)
2-52
5A High-voltage power supply PCB
transfer error.
2-52
5B It was detected that the length of
the paper under printing was
less than the specified value.
2-53
Error
codes
Problem
Refer
to:
5C It was detected that the size of
the paper was less than the
specified value.
2-53
5D The belt unit will reach the end
of life soon.
2-53
5E Belt unit is at the end of life. 2-53
5F The waste toner box near full.
(The sensor detected that the
waste toner became near full.)
2-54
60 Cyan toner cartridge is at the
end of life.
2-55
61 Magenta toner cartridge is at the
end of life.
2-55
62 Yellow toner cartridge is at the
end of life.
2-55
63 Black toner cartridge is at the
end of life.
2-55
64 The cyan toner cartridge will
reach the end of life soon.
2-56
65 The magenta toner cartridge will
reach the end of life soon.
2-56
66 The yellow toner cartridge will
reach the end of life soon.
2-56
67 The black toner cartridge will
reach the end of life soon.
2-56
68 Fuser unit error. (The
temperature rise is detected
even after the halogen heater is
turned OFF.)
2-56
69 Fuser unit error. (The connector
of the center thermistor is
inserted incorrectly.)
2-56
Error
codes
Problem
Refer
to: