113
B
Error and maintenance messages B
As with any sophisticated office product, errors may occur and consumable items may need to be
replaced. If this happens, your machine identifies the error or required routine maintenance and
shows the appropriate message. The most common error and maintenance messages are shown
below.
You can clear most errors and perform routine maintenance messages by yourself. If you need
more help, the Brother Solutions Center offers the latest FAQs and troubleshooting tips:
Visit us at http://solutions.brother.com/
.
Troubleshooting B
Error Message Cause Action
Access Denied The function you want to use is
restricted by Secure Function
Lock.
Contact your administrator to check your
Secure Function Lock Settings.
Access Error The device is removed from the
USB direct interface while the
data is processing.
Press Stop/Exit. Reinsert the device and try
to print with Direct Print.
Calibrate Calibration failed. Press Mono Start or Colour Start and try it
again.
Turn off the machine. Wait a few
seconds, then turn it on again.
Put in a new drum unit. (See Replacing
the drum unit on page 75.)
Put in a new belt unit. (See Replacing
the belt unit on page 81.)
Put in a new waste toner box. (See
Replacing the waste toner box
on page 86.)
If the problem continues, call your
Brother dealer.
Cartridge Error
Put the Black (K)
Toner Cartridge
back in.
1
1
The toner cartridge
colour with the
problem is shown in
the message.
The toner cartridge is not installed
correctly.
Pull out the drum unit and remove the toner
cartridge for the colour that is indicated on
the LCD, then re-install the toner cartridge in
the drum unit.
Comm.Error Poor telephone line quality
caused a communication error.
Try sending the fax again or try connecting
the machine to another telephone line. If the
problem continues, call the telephone
company and ask them to check your
telephone line.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
