116
Jam Inside The paper is jammed inside the
machine.
(See Paper is jammed inside the machine
on page 127.)
Jam MP Tray The paper is jammed in the MP
tray of the machine.
(See Paper is jammed in the MP tray
on page 123.)
Jam Rear The paper is jammed in the back
of the machine.
(See Paper is jammed at the back of the
machine on page 125.)
Jam Tray 1
Jam Tray 2
The paper is jammed in the paper
tray of the machine.
(See Paper is jammed in paper tray 1 or
tray 2 on page 124.)
Limit Exceeded The printing limit set by Secure
Function Lock 2.0 was reached.
Contact your administrator to check your
Secure Function Lock Settings.
Low Temperature The room temperature is too low
for the machine to operate.
Increase the room temperature to allow the
machine to operate.
No Belt Unit The belt unit is not installed
correctly.
Re-install the belt unit. (See Replacing the
belt unit on page 81.)
No Paper The machine is out of paper or
paper is not correctly loaded in
the paper tray.
Do one of the following:
Refill the paper in the paper tray.
Remove the paper and load it again.
If the problem is not resolved, the paper
pick-up roller may need to be cleaned.
Clean the paper pick-up roller. (See
Cleaning the paper pick-up rollers
on page 109.)
No Permission You have attempted to print in
colour using a Secure Function
Lock ID that is restricted to mono
printing only. The print job will be
cancelled.
Contact your administrator to check your
Secure Function Lock Settings.
No Response/Busy The number you dialled does not
answer or is busy.
Verify the number and try again.
No Toner The toner cartridge for the colour
indicated on the LCD is not
installed correctly.
Pull out the drum unit. Take out the toner
cartridge for the colour indicated on the
LCD, and then put it back into the drum unit.
No Tray The paper tray indicated on the
LCD is not installed properly.
Re-install the paper tray that is indicated on
the LCD.
No Waste Toner The waste toner box is not
installed properly.
Re-install the waste toner box. (See
Replacing the waste toner box on page 86.)
Not Available The requested function is not
permitted to all IDs by Secure
Function Lock 2.0.
Contact your administrator to check your
Secure Function Lock Settings.
Error Message Cause Action
To Next Page
Loading...
