Chapter 2
12
b While pressing the green paper-guide
release lever (1), slide the paper guides
to fit the paper size you are loading in
the tray. Make sure that the guides are
firmly in the slots.
c Fan the stack of paper well to avoid
paper jams and misfeeds.
d Put paper in the tray and make sure:
The paper is below the maximum
paper mark (b b b) (1).
Over filling the paper tray will cause
paper jams.
The side to be printed on must be
face down.
The paper guides touch the sides of
the paper so it will feed properly.
e Put the paper tray firmly back in the
machine. Make sure that it is completely
inserted into the machine.
f Lift up the support flap (1) to prevent
paper from sliding off the face down
output tray or remove each page as
soon as it comes out of the machine.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
