Brother MFC-9970CDW - Ethernet (Wired Network Only); Status (for DCP-9055 CDN, MFC-9460 CDN and MFC-9465 Cdn);Wired Status (for MFC-9560 CDW); Setup Wizard (Wireless Network Only); WPS or AOSS (Wireless Network Only)

Control panel setup
34
5
Ethernet (wired network only) 5
Ethernet link mode. Auto allows the print server to operate in 100BASE-TX full or half duplex, or in 10BASE-T
full or half duplex mode by auto negotiation.
Note
If you set this value incorrectly, you may not be able to communicate with your print server.
Status (For DCP-9055CDN, MFC-9460CDN and MFC-9465CDN)/Wired Status
(For MFC-9560CDW) 5
This field displays the current wired network status.
Setup Wizard (wireless network only) 5
The Setup Wizard guides you through the wireless network configuration. (For more information, see the
Quick Setup Guide or Using the Setup Wizard from the control panel on page 16.)
WPS or AOSS™ (wireless network only) 5
If your WLAN access point/router supports either Wi-Fi Protected Setup (PBC
1
) or AOSS™ (Automatic
Wireless mode), you can configure the machine easily without a computer. (For more information, see the
Quick Setup Guide or Using WPS or AOSS™ from the control panel menu to configure your machine for a
wireless network (Automatic Wireless mode) on page 16.)
1
Push Button Configuration
WPS w/PIN Code (wireless network only) 5
If your WLAN access point/router supports Wi-Fi Protected Setup (PIN Method), you can configure the
machine easily without a computer. (For more information, see Using the PIN Method of Wi-Fi Protected
Setup on page 24.)
WLAN Status (wireless network only) 5
Status 5
This field displays the current wireless network status.
Signal 5
This field displays the current wireless network signal strength.