Brother MFC-J450DW - Stop Faxing; Setting Scanner Glass Size for Faxing; Color Fax Transmission

Sending a fax
25
4
e Press Black Start or Color Start.
Faxing from the ADF 4
 The machine starts scanning and
sending the document.
Faxing from the scanner glass 4
 If you pressed Black Start, the
machine starts scanning the first
page. Go to step f.
 If you pressed Color Start, the LCD
asks if you want to send a color fax.
Press 1 to choose Color fax to
confirm. The machine starts
scanning and sending the document.
f When the LCD asks you Next Page?,
do one of the following:
 To send a single page, press 2 to
choose No(Send) (or press
Black Start again).
The machine starts sending the
document.
 To send more than one page, press
1 to choose Yes and go to step g.
g Place the next page on the scanner
glass.
Press OK.
The machine starts scanning the page.
(Repeat steps f and g for each
additional page.)
h After all the pages have been scanned,
press 2 or Black Start to start.
Stop faxing 4
To stop faxing, press Stop/Exit.
Setting scanner glass size for
faxing 4
When documents are A4 size, you need to
set the Scan Size to A4. If you do not, the
bottom portion of the faxes will be missing.
a Load your document.
b Press (FAX).
c Press a or b to choose
Advanced Settings.
Press OK.
d Press a or b to choose
Glass ScanSize.
Press OK.
e Press a or b to choose Letter or A4.
Press OK, and then press Clear.
f Enter the fax number.
g Press Black Start or Color Start.
NOTE
• You can save the setting you use most
often by setting it as the default setting.
(See Advanced User’s Guide: Setting
your changes as the new default.)
• This setting is only available for sending
documents from the scanner glass.
Color fax transmission 4
Your machine can send a color fax to
machines that support this feature.
Color faxes cannot be stored in the machine’s
memory. When you send a color fax, the
machine will send it in real time (even if
Real Time TX is set to Off).