Chapter 5
30
• (USA only) If you redial from the Caller ID
history outside your area code, you must
set up your AREA CODE in advance.
(See Setting up your area code (USA
only) uu page 27.)
• You can print the Caller ID List.
(See How to print a report uu page 35.)
Dialing access codes and
credit card numbers 5
Sometimes, you may want to choose from
several long distance carriers when you send
a fax. Rates may vary depending on the time
and destination. To take advantage of low
rates, you can store the access codes of long-
distance carriers and credit card numbers as
Speed Dial numbers. You can store these
long dialing sequences by dividing them and
setting them up as separate Speed Dial
numbers in any combination. You can even
include manual dialing using the dial pad.
(uuBasic User’s Guide: Storing Speed Dial
numbers)
For example, you might have stored “555” on
Speed Dial: 03 and “7000” on Speed Dial: 02.
You can use them both to dial “555-7000” if
you press the following buttons on the
Touchscreen:
a Press .
b Press #03.
c Press Send a fax.
d Press Speed Dial.
e Press #02.
f Press Send a fax.
g Press Black Start or Color Start.
You will dial “555-7000”.
To temporarily change a number, you can
substitute part of the number with manual
dialing using the dial pad. For example, to
change the number to 555-7001 you could
press , press #03, press Send a fax
and then press 7001 using the dial pad.
If you must wait for another dial tone or
signal at any point in the dialing sequence,
create a pause in the number by pressing
Redial/Pause. Each key press adds a
3.5-second delay.
To Next Page
Loading...
Need help?
General
