11 - 3 TROUBLESHOOTING AND ROUTINE MAINTENANCE
(For MFC-5440CN)
No Paper Fed
(For MFC-5840CN)
No Paper Fed #1
No Paper Fed #2
The MFC is out of paper. Add paper, and then press Mono Start or
Colour Start.
The paper is jammed in the MFC. See Printer jam or paper jam on page 11-6.
The paper loaded in Tray#2 is the
wrong size or type.
(For MFC-5840CN only)
Check the paper loaded in Tray#2. You can
only use plain paper sizes Letter, Legal, A4,
Executive or B5 in this way.
No
Response/Busy
The number you dialled does not
answer or is busy.
Verify the number and try again.
Not
Registered
You tried to access a Speed Dial
number that is not programmed.
Set up the Speed Dial number.
(See
Storing Speed-Dial numbers
on page
5-1.)
Out of Memory The MFC’s memory is full. (Fax sending or copy operation in process)
Press Stop/Exit and wait until the other
operations in progress finish and then try again.
—OR—
Clear the data in the memory. To gain extra
memory, you can turn off Fax Storage. (See
Setting Fax Storage on page 6-2.)
—OR—
Print the faxes that are in the memory.
(See Printing a fax from the memory on page
4-5.)
(Printing operation in process)
Reduce print resolution.
Paper Jam Paper is jammed in the MFC. (See Printer jam or paper jam on page 11-6.)
Wrong Paper
Size
Paper is not the correct size. Reload the correct size of paper (Letter, Legal
or A4), and then press Mono Start or Colour
Start.
ERROR MESSAGES
ERROR
MESSAGE
CAUSE ACTION
To Next Page
Loading...
Need help?
General
