1 - 16 INTRODUCTION
4
Fan the stack of paper well to avoid paper jams and mis-feeds.
5
Gently insert the paper into the paper tray print side face down
and the leading edge (top of the paper) in first.
Check that the paper is flat in the tray and below the maximum
paper mark.
6
Put the output paper tray back on and push the paper tray firmly
back into the MFC.
■
Make sure the paper side guides touch the sides of the
paper.
■
Be careful that you do not push the paper in too far; it may
lift at the back of the tray and cause feed problems.
Maximum Paper Mark
To Next Page
Loading...
Need help?
General
