62
Cannot Print
Refill [XX] Ink
The amount of remaining ink in one or
more of the ink tanks is low. The
machine will stop all print operations.
This error message may appear if the
ink dot counter is incorrect even if
some ink remains.
Refill the ink tank.
When you refill the ink tank, fill the ink
up to the upper line, or fill with all of
the ink in the bottle if it does not
exceed the upper line.
A message may appear on the LCD
to verify whether the ink tanks were
refilled.
Press 1 (Yes) to reset the ink dot
counter for the refilled color.
Press 2 (No) for the non-refilled
colors.
(See Refilling the ink tanks
on page 52.)
Clean Unable XX
Init Unable XX
Print Unable XX
Scan Unable XX
The machine has a mechanical
problem.
Open the scanner cover and remove
any foreign objects and paper scraps
from inside the machine. If the error
message continues, do the following.
See Transferring your faxes or Fax
Journal report on page 69 before
disconnecting the machine so you will
not lose any important messages.
Then disconnect the machine from
the power for several minutes, and
then reconnect it.
A foreign object, such as a paper clip
or a piece of ripped paper, is in the
machine.
Close Ink Cover The ink tank cover is not locked in the
closed position.
Firmly close the ink tank cover until it
locks into place.
Comm.Error Poor telephone line quality caused a
communication error.
Send the fax again or connect the
machine to another telephone line. If
the problem continues, call the
telephone company and ask them to
check your telephone line.
Cover is Open The scanner cover is not locked in the
closed position.
Lift the scanner cover, and then close
it again.
Make sure the telephone line cord
and USB cable (if used) have been
guided correctly through the cable
channel and out the back of the
machine.
Data Remaining Print data is left in the machine's
memory.
Press Detener/Salir (Stop/Exit). The
machine will cancel the job and clear
it from the memory. Try to print again.
Error Message Cause Action
To Next Page
Loading...
