13
■ LED display on USB Direct Interface (PT-9800PCN only)
Lit Flashing fast
Cutter error Confirm that the tape is not jammed
in the printer. If necessary, turn the
printer off and on. If the STATUS
lamp continues to flash, contact the
reseller where the printer was
purchased or call Brother customer
service.
Roller holder error
Print head overheat error Turn the printer off and on.
Lit
Flashing very
fast
EEPROM error Turn the printer off and on. If the
STATUS lamp continues to flash,
contact the reseller where the
printer was purchased or call
Brother customer service.
Circuit board error
Not lit Lit Booting —
Lamp condition
Condition Remedy
Color Condition
— Not lit USB device not connected —
Green Lit USB device connected —
Red
Flashing HUB connected Disconnect USB device.
Flashing fast
Noncompliant USB device
connected
Disconnect USB device.
“Buffer full” error with USB
Direct Interface
Data sent from the barcode reader is
saved on the printer.
Do not use the barcode reader to
consecutively scan barcodes or use
the barcode reader with multiple
interfaces at the same time.
Flashing very
fast
Overcurrent
Disconnect USB device and turn the
printer off and on.
Lamp condition
Condition Remedy
Power button
(green)
STATUS lamp
(red)
PT9700PC9800PCN_US.book Page 13 Wednesday, October 7, 2009 11:58 AM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
