14
Getting ready to use your printer
Before creating labels with the printer, the following preparations are necessary.
Note
● The connection procedures are different depending on the operating system running on the
computer. They will also vary depending on whether a USB connection, serial connection or
network connection (PT-9800 PCN only) is used. For details on connecting the printer to your
specific computer, refer to “Connecting to a computer” (→ P.16).
Connecting the printer
Connect the printer to the power source and a computer.
For details, refer to “Connecting the printer” (→ P.15).
Installing the software
You will need to install the printer driver to use your
printer with your computer. You will also need to install P-
touch Editor label design software. For details on installing
this software, refer to “Installing the software for PT-
9700PC” (→ P.19) or “Installing the software for PT-
9800PCN” (→ P.22).
Creating labels
After setting up your printer you can start creating labels.
For details on how to design and create labels, refer to the
“Software User’s Guide” (PDF). For detailed feature
explanations, you may also reference the P-touch Editor
Help menu found in the software.
PT9700PC9800PCN_US.book Page 14 Wednesday, October 7, 2009 11:58 AM
To Next Page
Loading...
