108
Arranging Embroidery Designs (Layout & Editing)
Stippling stitch
Manual punch
If Satin Stitch, Fill Stitch or Prog. Fill Stitch is selected as the region sew type for the manual punching pattern,
feathered edge settings can be specified.
Run pitch
Specify the run pitch (length of one stitch).
This cannot be specified if the motif stitch is
used.
Short
The turns are
smoother.
Long
The turns are more
angled.
Spacing
Specify the spacing between adjacent
stitches.
Narrow
The pattern is finer.
Wide
The pattern is coarser.
Use Motif
To use a motif stitch in the pattern, select the check box, and then specify settings for the
following attributes.
Type and size of the
motif stitch patterns
c
“Motif stitch” in the “Line sewing attributes” on page 99.
H-Arrange
V-Arrange
Spacing
Run pitch
Feathered
edge
Specify the edge of the stitching
where the feathered edge is to be
applied.
When the check box is selected, a
feathered edge is applied to the
embroidery pattern in the Design
Page. Check the preview, and
then select the edge where the
feathered edge is to be applied.
Select a pattern for the feathered edge.
Click to display the Browse dialog box. Select the desired
pattern from the list of patterns that appears.
Top side of pattern
For <pattern11>
Bottom side of
pattern
For <pattern18>
Top edge only
Bottom edge only
Top and bottom
edges
Specify the width of the feathered edge
Short Long
Feathered edge settings not specified
Feathered edge settings specified
To Next Page
Loading...
Need help?
General