Printing Labels Using P-touch Template (RJ-3150 Only)
107
5
2 Refer to the example below, and scan the barcode for the number specified as the key number.
Example for key number 6:
Select template
3 Scan the “Number of serialised copies” barcode.
4 Specify the number of copies to be printed.
Refer to “For entering numbers” on page 187, and scan the barcodes for the three digits of the
number of copies to be printed.
Example for 5 copies:
5 Scan the “Begin printing” barcode, shown below.
For this example, labels with the numbers 1234567890 to 1234567894 will be printed.
• The Numbering field will increase by 1 with each label that is printed.
• The count will be stored in the printer, even if it is turned off.
• To reset the count to the original number, scan the “Initialise template data” barcode, shown below.
^TS006
^NN
005
^ID
To Next Page
Loading...
