Brother RJ-3150 - Cutting Roll Paper; When Using the Label Peeler (RJ-3150 Only)

Setting Up the Printer
13
1
Cutting Roll Paper 1
Roll paper can be cut using the printer's tear bar. Pull one edge of the ejected paper up and toward the other
edge diagonally.
1 Tear bar
WARNING
The tear bar is sharp. To avoid injury, do not touch the tear bar.
When Using the Label Peeler (RJ-3150 Only) 1
If the label peeler is used, printed labels can be automatically peeled off their backing paper before they are
fed out of the media exit. This is useful when printing large quantities of labels and apply them at an
inconsistent pace, because the peeler sensor prohibits printing the next label until it is removed from the
printer.
Note
• You can also view information about setting the label peeler and loading paper in Help. While the printer
is turned on, open the RD Roll compartment cover, and press the [Menu] button on the printer.
• A video on setting up the label peeler is available at the following address
http://solutions.brother.com/movie/d532/
1