Brother RJ-3150 - Page 128

Troubleshooting
119
8
When printing via the USB cable, the
printer repeatedly pauses and then
continues printing.
Is the printer set for sequential printing?
If so, set print mode to buffered printing.
For Windows Vista
®
/ Windows Server
®
2008:
Open printer properties from [Control Panel] - [Hardware and Sound] -
[Printers] and click [Printing Preference] button in the [General] tab. Click the
[Other] tab and choose the option [After one page of data is received].)
For Windows
®
7 / Windows
®
8 / Windows
®
8.1 / Windows Server
®
2008 R2 /
Windows Server
®
2012 / Windows Server
®
2012 R2:
Open printer properties from [Devices and Printers], right-clicking the printer
whose settings are to be changed, and selecting [Printing Preference].
Choose the option [After one page of data is received].
An error occurs when the roll cannot
be fed to the beginning of the
printing.
If a feed error occurs, use the Paper Size Setup of the Printer Setting Tool to
assign the correct paper settings to the printer.
The computer program should be
sending data to the printer, but the
POWER indicator does not blink
green.
(RJ-3050 only)
Make sure that the USB cable is connected firmly and correctly. Try using
another USB cable.
Depending on whether you are using Bluetooth or Wi-Fi, confirm that the
(Bluetooth) indicator or the (Wi-Fi) indicator is lit in blue. If it is not, check
the connection.
(See Connecting the Computer and Printer on page 24.)
The label is ejected with the backing
attached (when using the label
peeler).
(RJ-3150 only)
 Check that the RD Roll is set correctly (see Setting the RD Roll on page 10).
 Check that the peeler is set up correctly (see When Using the Label Peeler
(RJ-3150 Only) on page 13).
There is an error (when using the
label peeler).
(RJ-3150 only)
 Is the peeler set up correctly?
Check that the peeler is set up correctly (see When Using the Label Peeler
(RJ-3150 Only) on page 13).
Problem Solution