Brother RJ-3150 - Page 194

185
21
21
General Procedure for the P-touch Template Function 21
The general procedure for using the P-touch Template function is described below.
For details on specifying the various settings, refer to Printing Labels Using P-touch Template (RJ-3150 Only)
on page 92.
Before connecting the barcode reader to this printer, be sure to specify barcode reader settings and the
settings in the P-touch Template Settings tool specified during preparation. For a detailed procedure, see
Preparation on page 93.
a Use P-touch Editor 5.1 to create a template, and then transfer it to the printer.
b Connect the barcode reader to the printer.
c Scan the “P-touch template command” barcode.
This allows the settings to be specified or clears the previous settings.
d Scan the “Basic settings” barcode.
Specify the number of copies to be printed.
e Specify the appropriate settings (A, B or C).
A. Preset template printing
21
Scan the “Preset template number” barcode.
B. Barcode printing
21
1 Scan the “Select template” barcode, then the barcodes under “For entering numbers”.
2 Scan the barcode whose data is to be used or copied.
3 Scan the “Begin printing” barcode.
C. Database-assisted label printing
21
1 Scan the “Select template” barcode, then the barcodes under “For entering numbers”.
2 Scan the key barcode for the database data to be used.
3 Scan the “Delimiter” barcode.
4 Scan the “Begin printing” barcode.
f The specified label is printed.
Appendix C 21