Setting Up the Printer
15
1
c Peel off the first label of the RD Roll. Then, insert the RD Roll so that the top edge of the second label is
at the same height as the top edge of the media sensor plate.
Position the label where the media sensor can detect it.
d Close the RD Roll compartment cover. Make sure the label peeler is on top of the cover.
Make sure that the labels are not pinched by the peeler rollers. The backing paper of the labels may not
be peeled off.
e In order to remove any slack in the roll, lightly pull on the paper fed out of the paper outlet until no more
can be pulled out.
f Push both sides of the ( ) label peeler until it clicks into place.
1 Media sensor
To Next Page
Loading...
