Printer Setting Tool
73
3
7 Print Data after Printing
Select whether or not print data is erased automatically after it is printed.
Available settings: [Erase All Print Data], [Keep Print Data]
Sensor Adjustment Tab 3
If RD Rolls are being used, it is unnecessary to adjust the sensors.
1 Disable these settings
When this check box is selected, appears in the tab, and the settings can no longer be specified or
changed.
The settings in a tab where appears will not be applied to the printer even if [Apply] is clicked. In
addition, the settings in the tab will not be saved or exported when the [Save in Command File] or
[Export] command is executed.
To apply the settings to the printer or save or export them, be sure to clear the check box.
2 Media Sensor (Transmissive/Gap) (RJ-3150 only)
If RJ-3050 was selected for [Printer], this item is unavailable. The following transmissive/gap sensor
parameters can be adjusted.
[Detection Sensitivity]
Adjust the precision of the sensor that detects the gaps (spacing) for die-cut labels.
Available settings: -2–+2
[Luminescence Adjustment]
Adjust the amount of light emitted by the transmissive/gap sensor.
Available settings: -2–+2
1
2
3
4
To Next Page
Loading...
