INSPECTION AND MAINTENANCE 61
10
fuse will likely blow again.
If the fuse continues to blow, request an
authorized BRP dealer to inspect the out-
board motor.
1. Stop the engine and disconnect the
battery cable from the battery negative
(-) terminal.
2. Remove the engine cover.
3. Remove the fuse box lid.
4. Remove the fuse and check it. If the
fuse is blown, replace it with a fuse of
the same specified rating. The out-
board motor is supplied with spare
fuses in the spare fuse holder.
1. Fuse for charging system
2. Fuse for main circuit
3. Blown fuse
E15__US_EN_141125N.book 61 ページ ２０１４年１２月２６日 金曜日 午後２時４６分
To Next Page
Loading...
