Bryant Evolution Connex SYSTXBBWEC01-C - Heat Source (if Applicable); Zone Names (if Applicable)

55
15. Heat Source (If Applicable)
With the Evolution Connex Control, you can select the desired heat
source of your system, if your system is equipped as a HYBRID HEAT®
System. Select the HEAT SOURCE icon from the menu screen.
A170239B
NOTE: Options available on this screen will correspond to the
equipment attached. Options may appear that are different than those
shown, below.
• The default is for the system to Control the heat source.
• To have only the furnace Control, select FURNACE ONLY.
• To have only the heat pump, select HEAT PUMP ONLY.
• To have only electric select ELECTRIC ONLY.
• When you have made the appropriate selection, touch SAVE.
16. Zone Names (If Applicable)
With the Evolution Connex Control, you have the ability to customize
zone names. Select the ZONE NAMES icon from the menu screen.